Review on Raspberry Pi 7 Inch Touch Screen by Mayrando Clark

Case along with official v2 camera, RP 3 B and 7 inch screen arrived yesterday. I spent a few hours trying to figure out why the case didn't fit. The RP board is attached to the screen as shown in the YouTube installation video of the case. Not as easy as I saw in the video Install the case, unscrew all but one screw holding the RP to the screen. The remaining one is behind the wall mount hole, leave the screw loose to move the RP so its peripherals fit the holes in the case. Now everything fits. Except the screen mounting hole is offset by about 2mm so I had to insert the screws at an angle to achieve alignment. To replace SD cards (which requires removing and unscrewing the PB each time) you need to change this configuration each time. Either that or manually attach the case to the wall, stand, etc. upside down.