Review on Energy Suspension 3 5190G Greasable Sway by Gregory Shin

Already have a few of your parts on my pickup truck . As far as the brand is concerned, I'm satisfied. In the course of research I had to measure the diameter of the stabilizer bar to find the correct size bushing, which I did. After removing and installing the control arms, I found that the stabilizer bushings match the diameter, but the clamp holding them to the frame is NOT. It's significantly smaller compared to removing the OEM part, but my issue was that the placement at each end was close to a kink and the alignment had a lot more diagonal play than the bulky OEM socket and clamp (the last, what I wanted to do). at this point it is to tighten it and cross the screws to be able to install it on my car). I had to replace the intermediate arms and the stabilizer bushings WERE intact so I had to reinstall because of this issue. So only wishbones from the kit were used and I'm stuck with bushings and clamps that I can't install. Local parts stores may NOT have the best brands that I'm used to, but at least I can learn a lesson and after removing it I can take it with me and compare it to what's available there (I don't like removing anything). my car, not to install new gaskets, etc., but in this case circumstances did not allow me to do so).