Review on 📺 Long Arm TV Wall Mount - Swing Out Full Motion Design for Corner Installation | Mount-It! | Fits 40-70 Inch Flat Screen TVs | 220 Lb Capacity | 26 Inch Extension by Jamal Webb

Need an almost 90 degree angle for our 55 inch TV. Only about 40 pounds, but this one stretches the widest I could find and I don't have to worry about weight limits. In any case, I don't want it to be under 90 as I viewed it from the center of the room as it's hanging on the left wall. I was initially concerned that the original cleats I chose were closer to 17". I got these too so I had some room around the edges. Drill another hole if needed. Luckily moving over worked a stud better and they were 16" apart. The biggest problem was the supplied mounting screws. I pre-drilled the size recommended in the instructions. Tried my drill. He hardly moved. A charged battery did not help. I have used this drill on others before. Delays, no problem, this one started to burn. I could turn them by hand, the rest was with my socket wrench. I was also worried that they might be too long. But after considering the thickness of the fastener, washer, lock washer, it was close. Then I remembered the thickness of the drywall so that there is no fear that the beam will go completely through the stud. Don't trust the included bubble level attached to the bracket. I was convinced I checked that my holes were even and that the attachment was level by inserting the screws for the anchor. The connected plane was far away. Be sure to check the height of the end of the arm when it is fully extended where you want it before attaching the TV. I had to adjust mine. I put the TV on, everything is fine. The mount was well packed in 4 boxes and some bubble wrap. Somehow the visible side of the TV mount was scratched, missing paint and showing shiny metal. So I used a marker to color in. Also, the brackets are very long. My TCL mounting holes face the bottom of the TV so I had to use the bottom holes on the brackets. The brackets protrude 1/8-1/4 inch at the front and bottom, but it's not noticeable. Because TCL has a bulge under the VESA holes, I used thick plastic washers designed for a curved TV. Otherwise the brackets were tilted and not flush. I didn't have this problem with my other mount. These brackets are also very long. Handles But they don't seem to be that bad if I had to change the angle.