HOMELYLIFE 600W High Power Voltage Reducer DC 48V 60V 72V Step Down To DC 12V 50A Buck Converter Waterproof Module Car Truck Power Regulator Transformer Review

I purchased the 13.8 volt, 10 amp version of this converter to provide a constant voltage for a 2 watt transmitter (a Hamtronics 220mhz exciter). As the transmitter does not like the variability of DC voltages out of the solar charge controller, this seemed ideal. Sadly that was not the case.About two months after installation the converter failed as evidenced by the transmitter going off the air. The input voltage from the charge controller was still present, but the output from the converter…

I purchased this as a step down from my 24V Lifepo4 to 12v. It worked for around 1 hour then my Fish Finder and USB charger showed the voltage dropped to 11-10.x V. I'm not sure if my units are taking too much power or draw so I ordered another one doubling the AMP and Watts. I will do an update once i find out if the new unit does the same.

Super fast shipping, product as described, works EXACTLY as described, which is super nice. The unit doesn't get warm to the touch, but I'm only pulling 5 amps through it. Would buy again.

It is pretty well made but comes with absolutely no instructions in box. The wiring is clearly labeled on the back of the device with input/output. I bought two because I heard of some failing shortly after install. I have ClubCar DS precedent 48 volt. My only complaint so far is that access to screw holes it tight for anything other than screw driver. I use metal screws and drive them in with socket head. I struggled to drive in screws with drill. I didn't want to peak out the device so I only

Works just fine. Using it to convert 18v Li batteries to 12v to run a vexilar for ice fishing. Nice weight savings and I already had several tool batteries to use instead of buying new lead or dedicated lithium batteries for the flasher. Output volts is 11.8v. Would be nice if it were a little bit smaller but build is solid.

Really wanted to like this dc to dc converter unfortunately this unit lacks a adjustment for output power was running at 11.6v and with loads was in the mid 10 volt range had to return

My application is to run a CPAP machine from my 500wh Solar Power Station. These have lithium batteries with an unregulated output that swings from 12.5v down to 9v, which proved a problem when running with heated hose and water; It would shut off below 11.5v.With this regulator the CPAP machine sees clean power and runs wonderfully. The unit barely gets warm after hours of use. Now I'm set for camping and "Planned Power Outages".

Used mine to bring a 48 volt battery bank down to 12Vdc for LED lighting. Tested through a wide range of input voltage (44 to 60 Vdc) and output stayed right at 12 volts. I added a dimmer between the output and the LED lights. All works perfect. HINT: Watch your polarity if you are wiring LEDs. Highly recommended.

Mounted to an aluminum plate on the inside of a cabinet and used insulated crimp connectors to make all of my connections. It has been converting continueously since instulation and no signs of any issues.

I'm using it to provide regulated voltage from a lithium battery to my telescope. Very sturdy and well-made. Puts out a constant 12.25 volts. Good Product.

Item works exactly as described, when the voltage on the high side is reduced the voltage on the low side stays consitent. The unit does have have a higher than expected draw with no load, .1 a.

I'm running a speaker system that previously used a 120VAC to 24VDC 63W brick adapter. The system is now fed from this adapter connected to a 12V 20Ah battery/solar setup. This takes up much less room with less power waste and is working as expected with no issues so far.