Review on 💧 PureTouch AquaSuite MicroTech 9001 Replacement by Sherry Schneider

I've been using them for a while and only rely on a well known brand name. This is a professionally installed and configured under sink model, proven routing and correct connection to the system. I did a very simple water test before and after installing the last filter I bought. Using an electronic sensor, unfiltered water from an unfiltered faucet contained an average of 302 ppm dissolved solids. Then I installed the filter as instructed and let it run until the blinking LED turned green. Water tested from a "filtered faucet" also averaged 302 ppm. I know it's non-specific, but what are the odds that ppm are exactly the same with and without the filter in the loop? Am I expecting too much from this filter? As a control, we tested a 3-stage professional reverse osmosis water filtration system that we use to purify the water in our aquariums and it consistently read 000ppm using the same electronic tester. , very close to reverse osmosis, and a moderate use Brita filter jug tested at 225ppm. Anything is better than the new Moen filter. Unconfirmed Finding: When offered two bowls of water, our three cats always preferred drinking from the Zero Water jug to water filtered through Moen. Both were kept at room temperature to take temperature out of the equation. ter is produced on this scale by your register filter? If I am wrong please tell me what is the best way to test filtered water so I know it is working as intended. I would like to swap the filter for free to test and if I am satisfied that it works I will leave the Moen system.