Review on EDGE INDUSTRIAL Straight Brass Fitting Hydraulics, Pneumatics & Plumbing by Martin Alvarez
Will not fit all 1 " ID hoses.
The website lists the outside diameter of the NPT threaded end but not the outside diameter of the barb end. I tried it on a hose. with an inside diameter of 1" and it didn't fit, it was too loose to even consider. Had to return and pay for return postage! Waste of time ordering this part.
- Hydraulic, Pneumatic & Plumbing
- High Price
New products
Comments (0)
Top products in π§ Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
