Review on 💡 Gebildet 8pcs 12V-24V Add-a-Circuit Micro 2 Fuse Tap Kit: Piggy Back Blade Fuse Holder with Wire Harness, 9pcs Micro 2 Fuse (5A 10A 15A) and Fuse Puller by Isaac Islam

Generally satisfied. The only complaint I have is that there isn't enough space between the two fuses for them to fit perfectly. One of the fuses is slightly higher than the other because I can't get it down the last 1/16 inch (it interferes with the body of the other fuse). Since it's only 1/16 inch I'll call it good, but ideally both fuses should be fully seated and next to each other with enough room to fit a fuse puller in between. In this case, they collide with each other and there is no place for a fuse puller at all. However, I can use needle nose pliers and grab them by the ends instead of through the fuse body. Everything will be fine. I would give 5 stars if the fuses were a little further apart.