Review on AMT Pump 5381-95 Immersion Coolant Pump, Cast Iron, 0.125 HP, Three-Phase, 230/460V, Curve-A, 0.375 Inch by Micheal Chaplain

This is a good pump, well built. Mine came wired for 110v. The wiring diagram sticker on the outside of the motor is confusing as the actual wires are labeled/numbered differently than the wire numbers on the pump body grommet (this is a good idea to follow when changing voltage settings). The wiring diagram on the outside of the pump matches the numbers (difficult to see visually) found on the molded rubber grommet where the wires protrude from the motor. Ignore the cable numbers on the actual cables (this is a poor representation of the information, very misleading). I would replace the wire labels with letters to avoid confusion, or use wire colors for wiring instructions for different voltages.