Review on Brandmotion 9002 3003 Switchable Parking Sensors by Brian Samaiyar

It took about 4 hours to install the whole kit. I had to drill holes in the Fab Four's heavy metal rear bumper. The 3/4 hole saw included in the kit broke immediately. Bought a Milwaukee carbide hole saw. Zach from Tech Support was very helpful. Seems to work well, the meter/reading display is a bit difficult to figure out where to put it. Didn't want it on the dash. Put mine in the back. In this Tacoma setup, I needed a longer wire from the tail light power wire to the kit's electrical box, which I installed in the cabin behind the back seat. never mind With a sedan, you can put it in the trunk. An additional wire will most likely not be needed.