Review on LISEN Enhanced Magnetic-Friendly Smartphone by Micky Lovett

This was the third phone holder I bought to try. The first two were friction holders, but since I have a pop socket on my phone case, they don't hold my phone. I looked for the deepest phone holder but none worked. I sent them back and ordered these. It was a gamble because I thought I could attach a round metal plate to my popsocket and hold it, unfortunately the popsocket spins freely and because it's not perfectly centered on my phone case (to make room for the rear fingerprint sensor), would be he above down. Instead I used a rectangular metal plate between my phone and the case, but because the popsocket was off-center I had to place the plate in the bottom third of my phone. So I can't use landscape mode on my phone, but that's ok, it's solid enough to display my phone vertically. Another issue was that the double sided tape was too thick to fit between my phone and case, so I removed the tape with a razor (be careful) and that was enough to get between my phone and case fit. I also had to modify the vent mounting hook by adding a 1/2 inch wide piece of sprinkler riser to the back of the bracket and my vent, so my vents are flush with my dash. So as you can see I was determined to get this working. I wanted my popsocket and case not to be permanently attached to the phone itself. Sorry it's so long but I seem to want it all. Now it works great. I put another one on my wife's car (2014 Altima) and it attached well to the air vent with no rework, well I removed the tape (with a razor) and slipped the bare rectangular panel behind her phone between the case. If you've made it this far, congratulations! Buy this cell phone holder.