
The device works, but there are many problems. The micro USB port does not work at all. I could not connect the device via the port like comparable ublox boards can. I had the FTDI module and was able to connect the device to the U-Center BUT there is no Sram/EEPROM on this board so you cannot save a configuration. The default value is 57600 baud, 1 cycle per second. If it works for you it should work, but I need to be able to change the configuration.

Smart Column Yandex New Station Mini - smart column with Alice (with watch), black onyx
432 Review

💨 LEMOISTAR USB Car Fan, Powerful 4-Speed Wind Circulation Fan for Vehicles SUV RV, Rear Seat Cooling Fan with Durable Hook - 5V USB Powered
38 Review

Waterproof Hard Laptop Sleeve Case For MacBook Pro M1 14-Inch 2021, MacBook Air M2 13.3'' 2022-2018, MacBook Pro M2 13'' 2022-2016, Dell XPS 13, Surface, HP, Acer - Cloudy Marble Design By FINPAC
39 Review

StarTech.Com HDMI To VGA Cable – 6Ft 2M - 1080P – Active Conversion – HDMI To VGA Adapter Cable For Your VGA Monitor / Display (HD2VGAMM6)
38 Review

🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review

🗺️ CARRVAS GPS Navigation System for Car, 2021 MAP 7inch Truck GPS Navigation, Spoken Turn-by-Turn Directions, Speed Warning, USA, Canada, Mexico, Lifetime Maps Update
9 Review

🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review

✈️ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review