Header banner
Revain logoHome Page
Calvin Hodges photo
1 Level
784 Review
39 Karma

Review on ๐Ÿ–จ๏ธ Non-Brittle Creamy ABS-Like Curing Printing by Calvin Hodges

Revainrating 5 out of 5

Destroys the best FEP materials in 3D printing Consumables

Overall the resin is pretty good, the print is good but at the expense of the new FEP film on my printer. When you run this on Phrozen with the official settings from the Siraya website and after two prints it sticks so tightly to the FEP that it leaves a big gap where you print. I've reproduced this twice and wasted two FEPs which aren't cheap for a large Phrozen transformer. I tried changing exposure in case site options were off and that helped - same thing happened after 2 prints - FEP broke down.

Pros
  • 3D Printing Fluid
Cons
  • Out of fashion