This RioRand motor speed controller is perfect for my Watersnake trolling motor with 24 lbs of thrust. I was able to remove the ribs in the white top half and attach the controller with a single nut and bolt to attach the device to the top inner half. The 11 1/2 inch cable to the control switch was then routed through the handle and attached to the front of the trolling motor by drilling a 5/16 inch hole in the end of the handle. I cut off the inside of the handle leaving about 4 inches, but the outside of the handle is left flat. The controller was easy to connect in the head by cutting the red and black positive and negative wires to the battery terminals. Simply attach them to the device as shown in the picture. I also cut 10 inches off the shaft for use inside and in the Hobie drive.
Adjustable Regulator Generator PEMENOL Controller
9 Review
Universal Rotary Cam Selector Latching Switches - VictorsHome Changeover Switch LW28-32 With 3 Positions, 12 Terminals For 690V, 32A Capacity
9 Review
Vacuum cleaner KARCHER VC 3, yellow
176 Review
TWTADE/AC 24V 10A Coil Electromagnetic Power Relay 8 Pins 2DPT 2NO+2NC With Indicator Light And Socket Base -YJ2N-LY
9 Review
π Enhance Your Electrical Work with Klein Tools 69411 Accessory Adapters
7 Review
π Bussmann GMA 5A Acting Cartridge Listed: Reliable and Efficient Cartridge Fuse for Your Automotive Needs
7 Review
π Bussmann MDL 2 Glass Delay Slow Blow
8 Review
Square HOMT2020 Circuit Breaker Homeline
7 Review