Review on Airtex E3518M Fuel Module Assembly by Ryan Nguyen

Quality repair. Came with crimp butt connectors for the new wiring harness but I would recommend soldering the wires together and be sure to use heat shrink! The fuel pressure is restored and the sensor is finally correct. Good guide. CLEAN AREA OF ALL DEBRIS SUCH AS DIRT, SAND, RUST ETC. BEFORE REMOVING THE LOCKING RING. TO CLEAN! Keep in mind that the old one you remove may need to be cut with scissors to remove if it doesn't fit through the hole. It was faster to take the risk of deforming the hole on the tank. 3 different. The supplied O-rings meet your requirements exactly. Circlip, lots of cheap grease! Purchase a new snap ring ahead of time and use a large hammer and chisel. Lots of grease on o-rings and ring to make reassembly easier! Tip: Only do the wiring after you have installed the new pump and connected the lines. Ventilate the trunk a little to avoid smoke, then route the cables and you will have to trim them as they are too long.