Header banner
Revain logoHome Page
Josh Culotta photo
Singapore
1 Level
749 Review
44 Karma

Review on SUNLU 3D Printer Filament, Neatly Wound PLA Meta Filament 1.75Mm, Toughness, Highly Fluid, Fast Printing For 3D Printer, Dimensional Accuracy +/- 0.02 Mm (2.2Lbs), 330 Meters, 1 KG Spool, Black by Josh Culotta

Revainrating 3 out of 5

Disappointed best in my review

I had previously used SUNLU PLA+ (white) and was very impressed. It was not available when I tried to reorder it, so I figured I'd give this a try. Huge difference. This is very stringy and even after drying the filament, the prints have a lot of "zits". The roll also did not unwind smoothly and at one point, the filament broke during printing. I'll avoid the "meta" filament, but I will still buy PLA and PLA+ from SUNLU.

img 1 attached to SUNLU 3D Printer Filament, Neatly Wound PLA Meta Filament 1.75Mm, Toughness, Highly Fluid, Fast Printing For 3D Printer, Dimensional Accuracy +/- 0.02 Mm (2.2Lbs), 330 Meters, 1 KG Spool, Black review by Josh Culotta



Pros
  • With a dimensional accuracy of +/- 0.02 mm, you can be confident that your 3D prints will be precise and consistent
Cons
  • May produce fumes or smoke during printing