Review on AGPTEK Mig/Tig Flow Meter Regulator, Efficient CO2 Argon Pressure Reducer Gauge Weld Flowmeter - High-Quality Copper - 10 to 60 cfh by Ronnie Segobiano

As a welder I was hoping for feedback, I needed 2 regulators for argon bottles. I picked them up and they were well packaged and looked great in the box, but when I put them in I noticed problems. do not have a standard argon hose connection for Miller or Lincoln welders, they have a tapered end on the low pressure side that can be used by cutting off a standard threaded socket and then pressing the hose against the governor shaft. However this only works if the regulators aren't releasing gas from the fittings, in my case they both are and hold the pressure for no more than 3 seconds. At 12 l/min I lose about 5 l/min of gas from the porous fittings. But it's only $27. I would buy better if I had then