Review on 🚗 All-Fit Automotive Red Universal Bumper Lip Splitter Kit - Enhancing Style & Shielding Lower Bumper by Mike Groover

There are several of these products on the market and they all claim the same thing. I decided everything fits (medium lip) based on reviews. I plan to lower the car about 1.5 inches so the center lip gives it an almost slammed look without slamming it. (Picture before lowering) The installation was a bit more difficult than expected, but there was enough material to start over if necessary. I have a 1993 Mustang and the first turn had to be redone a couple of times but after that the installation went smoothly. I recommend pre-installing and determining where to make stress cuts before removing the adhesive backing. The hardware is enough to secure it in place so you don't want to lose it. Four stars out of five because the tape didn't last long enough to use the screws. I used parentheses. The instructions say you can only use duct tape, but I disagree. After the installation the car looks great and I am very satisfied. I also decided to cut each end of the chin spoiler to match the angle of the inner fender. Otherwise the corner sticks out quite a bit and doesn't look that good in my opinion.