Review on 1.75mm CarbonX Carbon Fiber Filament by Scoony Taker

Excellent excellent material. Excellent printability, minimal tension, good layer adhesion, excellent carbon finish. High CF content. Much harder than regular PETG. Prints preferably hot (250-255°C) and slow (30-35mm/s) without fan. Adheres very well to the Creality magnetic bed at 80 °C. A hardened nozzle is required. When they say it's an abrasive, they're not kidding: a roll of this material abraded a sharp point, or my MicroSwiss, presumably from a wear-resistant brass nozzle, lost 0.3mm in overall length (combing out in the slicer to avoid snagging to pull the nozzle). above the surface. It's a nozzle killer.) I have since switched to a tungsten carbide nozzle and stainless steel extruder gear as the brass was starting to wear out. Made in the USA!