Header banner
Revain logoHome Page
1.75mm carbonx carbon fiber filament logo

1.75mm CarbonX Carbon Fiber Filament Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(1)
img 1 attached to 1.75mm CarbonX Carbon Fiber Filament

Description of 1.75mm CarbonX Carbon Fiber Filament

Made in the USA. Superior Chemical Resistance vs. ABS. Amorphous: Low and near isotropic shrinkage. Low moisture absorption: 3X lower vs. ABS. Very low odor emitted during printing.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

You get what you pay for.

Awesome thread. The print quality is excellent. Enables flawless prints. The adhesion of the layers is very good. Lighter than Petg, less brittle and much stronger. Used for RC airplane parts. High carbon content.

Pros
  • nice thing
Cons
  • I don't remember but there was something

Revainrating 5 out of 5

Disappointingly bad results.

Poor layer adhesion. Nozzle 0.5mm at 255°C (can't imagine it sticking at all at the lowest 230°C) XY is super durable and looks good. together is better I would rate the optics higher, but if the small part (1x2x3cm) printed from the solid doesn't stick together, I can't give more than one star.

Pros
  • Lots of positive emotions
Cons
  • No performance

Revainrating 5 out of 5

I can't believe it's PETG!

Excellent excellent material. Excellent printability, minimal tension, good layer adhesion, excellent carbon finish. High CF content. Much harder than regular PETG. Prints preferably hot (250-255°C) and slow (30-35mm/s) without fan. Adheres very well to the Creality magnetic bed at 80 °C. A hardened nozzle is required. When they say it's an abrasive, they're not kidding: a roll of this material abraded a sharp point, or my MicroSwiss, presumably from a wear-resistant brass nozzle, lost 0.3mm in

Pros
  • Few competitors
Cons
  • unreliable