Review on 🖥️ Geekworm N100 Metal Case with Power & Reset Control Switch, Camera Holder - Optimized for Jetson Nano A02/B01/2GB/4GB and Jetson Xavier NX by Andre Pendergrass

Quality features such as large buttons, (apparently) welded front left and right edges, flush rear screws, camera strap/flex cable slots, smooth edges with no burrs, solid workmanship, good fit and alignment, better airflow than similar cases. In my opinion, this is the best Jetson Nano case currently available from Revain. However, below are suggestions for future improvements. If possible, use screws of the same type. The case currently uses 3 slightly different types of tiny black screws. The instructions do not specify which screws for which parts. The video shows different types of screws. Remove the cut outs in the front top corner and increase the clearance in the corner tabs to allow the panel to be sandwiched between the front edge and the side tabs. This eliminates top cover rattle and possible compression of the ribbon cable. Increase the diameter of the fan cutout to match the size of the recommended fan. Add 4 corner holes on the top to properly attach the recommended fan to the top plate using the silicone bumpers or screws included with the Noctua fan. This improves airflow by eliminating the 2mm gap to the case. Also eliminates the hazard of plain nuts under the heatsink vibrating loose and becoming stuck under the module, causing a short circuit. Saves 4 long bolts, 4 nuts, 4 washers, tweezers each. Makes fan installation much easier and doesn't require removing the Nano from the case. Include the intended airflow path somewhere in the instructions so we know which direction to install the fan. blow down and in or suck up and out. Thank you for making a quality kit.