Review on Efficient Aircraft Tool Supply Clamp Installer for Swift Installation by Brett Slater

This helps tighten those pesky Adel clamps just enough to fit a bolt and nut. Insert an awl through both holes in the yoke, install a vise (with two U-shaped flats) to press the two ends of the yoke together, and tighten just enough to remove the awl and free the bolt and nut can install. Remove the vise and all you have to do is tighten the clamp. They easily pay for themselves when replacing the motor, you save a lot of time, especially with large induction tube clamps and wire bundle clamps. leaves enough room for a 3/16 screw or bolt when removed. Nice metal, I've put a lot of pressure on these studs and they haven't buckled yet. The vise is about 6 inches long. Cons: Doesn't really work in very tight spaces. The vise will only open to a certain point when you want to squeeze the ends together tight enough to pull the awl out, so you'll have to pull the ends together to put it on. It's not really that important, but it's worth mentioning.