I'm not sure I did anything wrong if only they aren't that sticky. According to the instructions, I wiped the dents very clean. I used a paper towel with denatured alcohol on it and wiped it down a few times. It was clean. Then I added each letter individually. I did this without touching the bottom, just the sides of each letter. I lined it up and pushed hard into the recess. Everything went well. It was in my garage and about 50 feet at the time. After 2 days of rain and my truck parked (about 35ft) I noticed the letters were starting to fall off. I'm disappointed. Now I'm not sure what to do? Buy a different brand or apply new glue to the back of the letters.
🎀 96108K Bowtie for Chevy, Pair, Black - Enhanced SEO: "Black Pair of 96108K Chevy Bowties for Superior Sales Performance
9 Review
Smart electric grill Optigrill Elite GC750D30, thickness sensor
41 Review
American Emblem Trucks Forward Reverse Exterior Accessories for Emblems
9 Review
🌈 Vibrant Tri-color Front Grille Badge Emblem for Tacoma, 4 Runner, Tundra, Sequoia, Rav4, Highlander – Yellow/Orange/Red
9 Review
ORCISH 12V 13000-lb Load Capacity Electric Truck Winch Kit 🚚 with Synthetic Rope - Waterproof Off Road Winch for Jeep, Truck, SUV
35 Review
Nokian Tires Nordman RS2 SUV 225/60 R18 104R winter
32 Review
4WD ORCISH Recovery Traction Boards Tracks Tire Ladder For Sand Snow Mud - Set Of 2 (2Nd Gen Bag + Mounting Pins, Black)
39 Review
Nokian Tires Hakka Green 3 205/55 R16 94H summer
37 Review