A great idea that fails when it comes to implementation. This would make it much easier to identify the outlets since the stamped numbers are so tiny. only one problem Labels will not stick to steel. Glue is almost non-existent. The paper labels that were made for circuit breakers worked great. It's quite expensive to buy about eight labels. That's all I could use from 150 pieces in a pack. I was trying to label a brand new set of outlets that had never been used. So there was no grease or oil on the bushings. Stickers still mostly don't stick. They come off after a few minutes. Magnetic labels seem to work. Again, very weak magnets. Every time I open a drawer or door they slip and sometimes fall down.
Enhanced OTC 4461 6-Piece Automotive Terminal Release Tool Set with Convenient Case
8 Review
🚘 Enhance Your Vehicle's Trunk Control with GM Genuine Parts D1482E Trunk Lid Release Switch
7 Review
Steelman 23-Piece Terminal Tool Kit for Automotive Technicians, Safely Extract Wires from Terminal Blocks without Causing Damage, Wide Range of Blade Styles for Versatility
7 Review
🔧 Vignee Terminal Removal Tool Kit - 80Pcs Pin Terminal Extractor Kit for Cars, Wire Connector Pin Release Key Extractor Tools Set - Ideal for Most Connector Terminals - Includes Protective Bag
7 Review