Review on Veeology Filament MasterSpool Dimensional Accuracy by Janis Janis ᠌

Sooo good print, easy settings. I print at 210 table at 60. The figure is just a bomb. Moreover, I bought different plastic, I was looking for a really worthy one, as a result, they all get stuck, then they don’t like something in the temperature, although everything is according to the recommendations, then it sticks off, then it is smeared, there are no such problems with this one, but there is one annoying one. The second time I spend a lot of time and redo the figure because in the middle the plastic gets tangled and does not feed into the printer, the third time I had to unwind everything and figure out where the knots are