So I have MDX. There is a problem with chemical corrosion, cold welding. all with rotors on axial spindles. Heat, knock with a hammer, it is impossible to remove them. This device is bomb! Super easy to use and rich in content! Pushed the rear rotors as far as they could go, tapped them a few times with a ball head hammer and BAM, they came loose. I stood back from one for a minute and heard it pop. Each was removable with little effort other than tightening the drive bolt to the maximum possible. I didn't have the right socket size so I used two large crescent wrenches to get the job done. They easily replace the old tools. A note included in the instructions, be sure to tighten some nuts so the rotor doesn't pop out and cause other damage. For example, when you kneel in front of him. Comes off hard.
🔧 Astro Pneumatic Tool 78825 25-Piece Master Front Wheel Drive Bearing Puller Set with Grade 8 Drive Bolt
9 Review
🔧 Pro-Grade 18212 4" ADJUSTABLE 2 OR 3 JAW GEAR PULLER: Ultimate Versatility for Efficient Gear Removal
9 Review
🔧 Lisle 41970 Pitman Arm Puller - Heavy Duty Tool Specifically Designed for Ford Vehicles
9 Review
💪 Get Efficient Hub Removal with OTC (7394) Universal Hub Puller
11 Review