Review on Products Insert Heat Sink Injection Hardware by Jonathan Unruh
Work very well! on fastener
I used these in a straight hole 4.5mm wide x 5.5mm deep on a 3D printed plastic part. They went straight in and were very well behaved. 3D printed holes in my printers are 0.4mm narrower than intended, like most printers, without compensating for this in the slicer software. Thus, after printing, the holes have a width of about 4.1 mm. This provides very good coverage around the insert with minimal plastic breakout.
- Industrial & Scientific
- Some problems
New products
Comments (0)
Top products in 🔩 Nails, Screws & Fasteners
🔩 Eowpower 50 Pieces of 1/4"-20 x 7/16" Zinc Plated Tee T-Nuts with 4 Prongs
10 Review
Amino acid Prime Kraft 2:1:1, green apple, 150 gr.
27 Review
Nokian Tires Hakkapeliitta 9 175/65 R14 86T winter
36 Review
Wall-ceiling lamp Estares Saturn 60W R-470-SHINY/WHITE-220-IP44, 60 W, 47 x 47 cm, armature color: white, shade color: white
13 Review
Another interesting products
Eco-Friendly Solarez UV Cure Grain Filler & Sealer - Perfect For Fine Furniture, Guitars, Pool Cues And DIY Woodworking!
10 Review
Gorilla Waterproof Patch & Seal Liquid - Black 16Oz - Ultimate Solution For Quick Fixes (Pack Of 1)
39 Review
Hemway Glitter Grout Tile Additive: Sand Gold Sparkle For Your Bathroom, Kitchen And Wet Room Tiles - Easy To Use And Temperature Resistant!
10 Review
Pack Of 1 Natural Wood Color 8 Ounce Bottle Gorilla Wood Glue
42 Review