Review on 💡 Thermaltake TOUGHRAM Z-ONE RGB DDR4 3200MHz 16GB (8GB x 2) 16.8 Million Color RGB Memory - R019D408GX2-3200C16A by Sean Andrews

I'm a little smaller than Monsoon same size tubing (I use Monsoon fittings) but the Monsoon fitting comes with 2 sets of sealing washers so no problem. They seem to be softer to cut compared to the monsoons I use. Also heats up faster compared to Monsoon PETG. Update 10/16/19: I'm dragging my ITX build to move it to an ITX case. I noticed that the hose in the fitting was shrinking/deforming. There was a loosening feeling, the o-ring around the tube was loose. The compression ring dangled from the tube. When I inserted the compression tube into the tube where it was outside of the installation area. Again, as expected, it was tight. I took the straight edge to the pipe and sure the spot was slightly bent under the compression of the fitting. I used the white card in the picture to photograph it better. So it's a WARNING, watch out for leaks. My 8700k in a 240 rad thin ITX case hit a high 60C in Ghost Recon Breakpoint. IDK whether warmer water caused this or not. Back to the monsoon hose. They were harder to cut because they weren't soft. Overall I would buy again due to the price, lower bending heat and faster cutting due to the softer PETG (if you've cut a lot of pipe in the past you'll notice this). PETG is PETG so don't worry. These are excellent quality items. *** I will not buy again, too soft and deformed in the fitting. Use it but be careful. I order 2 packs, 1st pack was ok, my threadripper build is still good. The ITX build used the tube from the 2nd pack, so I'm not sure if the 2nd pack is defective or not. I won't know until I upgrade and take the pipes out of the fittings.