Review on π© Dernord Stainless Steel Hose Barb Fittings by Greg Roberts
ATTENTION! A 1 " barb is too small for a 1 " PVC plumbing line.
The 1" NPT to 1" fitting looks good but note that the side of the pin is too small to fit standard PVC piping. There is a gap of about 1/16 inch between the fitting and the hose. I couldn't make it airtight. I am returning them because they are useless to me. I ended up going to a hardware store and bought some electroplated ones that worked properly to finish my project.
- Fittings
- old
New products
Comments (0)
Top products in π§ Fittings
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
