Here are some instructions I used to hook up the auxiliary connector to my Polaris Ranger's bed. Since it is only rated for 5A I decided to connect this switch to a relay. That way I was able to hook up a 20A aux to my bed next to it. If 5 amps suit you then you don't need a relay. Instead, just connect what I call the + signal to your load and run a wire from the negative load post back to your battery or chassis ground. Use the Always On setting if you want the light to be on all the time, e.g. B. for dimly lit areas. Use circuit status mode when you want a halo to show if the load is on or off. Use "Push Me" mode to encourage people to interact like at a science fair. Arduino and made the Halo Pulse to really grab people's attention.
Xiaomi Mi Robot Vacuum-Mop 2 EU, white
82 Review
Yokohama Geolandar A/T G015 215/65 R16 98H all season
83 Review
5-Pack 12V/20A Red LED Illuminated 3Pin HOTSYSTEM Rocker Toggle Switch SPST ON/Off Carbon Fiber Cover For Car Truck Boat Motorcycle
45 Review
HOTSYSTEM 5 Blue + 5 Red + 5 Green Dot LED Light Round Rocker Toggle Switch SPST On-Off Control For Car Truck
24 Review