Review on Nilight 90001R LED Light Bar Rocker Switch Red 5Pin Laser On/Off LED Light 20A/12V 10A/24V Switch Jumper Wires Set by Zachary Spaulding

Information from Nilight: Product Size: 1.9"(48.3mm) x 1.04"(26.3mm). Mounting Hole Size: 37mm (1.43") x 21.3mm (0.84") Although a wiring diagram is included with the switch, it is not as clear as it should be. There are other ways to get different results with terminals. I wanted to connect a light to the IGN switch so that the LED bar switch TEXT ON ONLY lights up when the IGN switch is on and the LED ONLY lights up when the LED bar is used at night. The way I wired it was as shown on the website, but see below for further explanation: CONNECTION INSTRUCTIONS: I wired the switch so that the TEXT switch indicator light is on during NIGHT operation and operation of the LED panel is limited ONLY when it is ignited. was on and the TEXT rocker switch lit up when the key was turned on, but the ICON did NOT light up until the actual LED strip was turned on with the switch: terminals 2 and 6 need to be connected together. which comes from your ignition switch (12 volts +). Pin 3 connects to the RELAY for the LED bar and only energizes the relay to transfer battery power to the LED bar (Pin 3 does not power the actual lights, there is a heavier 12 volt wire straight from the battery to the Relay). which has a built-in fuse that powers the real LED panel). Terminals 7 and 8 are connected by a jumper and are used as GND for the TEXT and SYMBOL displays. NO terminals for 1, 4 or 5.