1 Level
1304 Review
58 Karma
Review on KOOTANS Brass Coupler Fitting Quick Connect by Sean Davis
The threaded part is too short.
Threaded section short, end too large. I had to tap the thread deeper to be shallow enough to start my hardware cutting into the hex. I used one on my welder for gas supply. The threaded section should be 1/8" longer so it's smaller and has enough taper to fit properly.
Pros
- Hydraulic, Pneumatic and Plumbing
Cons
- No Power
New products
Comments (0)
Top products in π§ Fittings
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
3.88
14 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
3.75
13 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
3.24
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
3.86
16 Review
