Review on 🚚 AMP Research 75306-01A BedStep Retractable Bumper Step for Ram Trucks 2009-2018 (1500) 2010-2018 (2500/3500, Excluding Dual Exhaust & EcoDiesel Models), Black by Tommy Hilmy

Initial install time 30 minutes HEADS: - Alignment of spacers in the instructions was incorrect. - Not all necessary tools were listed, I give 1 star for that and for the lack of care during training. Product development first had to go through some dry runs and revise their instructions to include ALL the tools and best practices. - A 10mm flex head ratchet wrench is very helpful when removing the bumper bracket on the RAM 2500/3500. The tolerances are too small for the nest. (TEKTON WRN57170) - A flashlight/torch will help work under your vehicle by aligning the screw holes. - The 3" extension is very helpful when attaching the rocker panel to the bumper with 15mm bolts as the holes are deep countersunk and you can't turn the bolts with a nut unless you have one very very deep 15mm nut. . Any magnetization is helpful in holding the bolt in place for horizontal installation, which you do upside down on your side. Not everyone has an elevator. Tip: Install the bottom screw first. It's not a bad idea to use a 3/16 T-handle allen wrench as a wrench of sorts on the top bolt hole to align it a bit and hold it in place. You will later use a 3/16 allen wrench to install the stepped part. Without using the socket wrench itself, just use socket extension and socket 15mm, insert the screw into the socket and gently turn it with your fingers so you can feel if it goes into the hole. Once you can't turn it with your finger it won't strip the bolt, then use a torque wrench to tighten it to the specified torque. or Freight sells a small digital torque wrench adapter that can be used with any attachment.