Header banner
Revain logoHome Page
Austin Hampton photo
United Kingdom
1 Level
722 Review
50 Karma

Review on Eliminate Headlight & License Plate Light Errors With TUINCYN 50W LED Load Resistors & Flash Capacitor Decoder Wire: DIY 4 Piece Kit by Austin Hampton

Revainrating 5 out of 5

Worked great on my 2016 Jeep Wrangler brake/turn signal

Original brake/turn signal lamp went out so I replaced it with an LED and had the flashing issue. This was a simple install. I had no issue with the length of the leads and I ended up cutting the included wires a little short. Even though it says to use two for one side for 3157 bulb, I used one resistor on each bulb. Ground wire and yellow stripe for positive.

img 1 attached to Eliminate Headlight & License Plate Light Errors With TUINCYN 50W LED Load Resistors & Flash Capacitor Decoder Wire: DIY 4 Piece Kit review by Austin Hampton

ο»Ώ

Pros
  • Very good quality.
Cons
  • The LED load resistors and flash capacitor decoder wire may not completely solve headlight or license plate light errors in all cases, making it a potential waste of money for those who experience continuing issues