Header banner
Revain logoHome Page
Todd Mamat photo
Ukraine, Kiev
1 Level
710 Review
11 Karma

Review on Inflator Inflation Campbell Hausfeld MP600000AV by Todd Mamat

Revainrating 1 out of 5

Very poor workmanship; keep looking for something better!

I assumed something sold under the CH name would be at least decent, but that's a shame. I bought two of these, one for my small work area off the kitchen and the other for the shop in my shed 200 feet away. The injection molded body is very sloppily machined so that air escapes from the threaded hole designed to accept the 1/4" NPT insert; air escapes there on both assemblies. No amount of tightening will result in a gas tight connection there Even though I used teflon tape on the quick connect nipple the leak in the housing is still there.If I tick enough I will disassemble the whole unit and use some paste.Put pipe sealant on it hoping to fill the gaps one of the two bleed valves was screwed in so that it was pinching the o-ring at an angle with the valve being only partially screwed in and not so obviously that connection couldn't hold a gas tight connection, I fixed it and installed the o-ring correctly , both pressure relief valves are sticking, and the only way to completely close them is to snap them shut . digging, not just releasing the thumb pressure. They're too cheap to justify a return, but I'd be surprised if I get two seasons of them before they fall apart completely. I would advise you to capitalize on my dissatisfaction and buy something else.

Pros
  • Everything is fine!
Cons
  • Exchange availability