Review on 🖥️ Enhance Your Workspace with MOUNTUP Dual Monitor Desk Mount - Fully Adjustable Double Monitor Arm with Gas Spring, Fits 2 Screens 17-32", Holds up to 17.6LBS Each - MU0024 by Lynn Cole

I was afraid to buy this because of the much lower price compared to other almost identical products; but everything seems to work well. The item arrived at 90 % mounted on so very little installation effort is required.Clamp C, which runs around the back of the table, is very flat, about 1-1/2" from the back plate to the center of the clamp face that presses down. on the Table. This was almost a problem for me as my table has a 0.75" edge before the support bar crosses the floor. (see photo) I rotated very hard to compensate for the lack of good contact at the clamp. It's very snug now, but I have a feeling it can loosen over time If you can attach it with a grommet or have a clean, flat edge to clip on to, then you generally won't have a compatibility issue have me The arms articulate well and I had no trouble mounting my two 27-inch monitors and moving them to appropriate locations. My monitors weigh 12-14 pounds each and the factory tension setting happened to work well for them so I didn't have to adjust the springs at all. Cable management is decent and should support most of the articulation, although I accidentally flipped the covers off when moving into some extreme positions due to the tension of the monitor's thick cables. So leave it a little loose to allow for full range of motion.