Pros: * decent price * feature seems to work as advertised. The documentation is only useful if you use WiringPi.Cons: * The contact header is not passed through. I ended up adding another pass-through connector at the bottom for some distance and added longer threaded posts to compensate. * PCB traces for relay contacts are visible on the underside of the PCB; This is not very safe if you want to use the mains voltage control board (120VAC)! I added a layer of Kapton tape to the bottom to prevent accidental shorting and "smoke blowing". *Relay J2 uses GPIO 4, which conflicts with the default 1-wire functionality on the RPi. It would be nice if there was some kind of configurability with jumpers etc. It would also be nice if it was mentioned in the wiki documentation. Overall I'm happy with these boards. It would be nice if the vendor included the schema in the documentation, but I understand that this leads to a simple design.
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review