Review on Ga Ferrules 0.71 Pin Lg: Optimal Connector Solution for Precision Wiring by Eric Pavelko

It definitely fits well, but don't expect it to slip over loose wires. Use a twist around the end and twist very tight. Then start on one side and slowly feed the wire end in. You may lose a few threads, but it's better than no connection in the long run. Once it starts, rotate in one direction until you can't anymore, then rotate in the opposite direction and watch it slide straight ahead. .Adult Advice: Don't complain if you can't understand. To attempt. You are an adult, solve the problem. I'd love to see some copper versions of this. Edit: A clean cut is required, do not chop the end with old router bits or a spare tool or use the old end as well, you want a fresh clean cut end.