The die blocks on the pipe must be fully closed before the nut is screwed on. I couldn't even close them with a heavy c-clip on the original Ford 3/16 inch pipe. This threaded hole on the die blocks is not narrow enough to fit the nut. This works for Nicopp tubes. because it is much softer, but reduces the outside diameter of the tube by several thousand. Both hose types measure exactly 0.187 inches. Also, the flare screw was deformed, too small and loose, but the nut thread size was correct, so I made another 1/2"-20 deg 5 flare screw. Now it makes decent flares in Nicopp, but that's the only one The way this tool would work.On steel pipe is to drill out the clamp teeth on the nose end and hope it doesn't slip.I wasn't aware Snap-On makes a tool like this and would have paid extra for it.So back to use the good old genuine Snap-On Blue Point Flare tools that work.
π§ Lang Tools 279-5420 279 Brake Caliper Press: The Ultimate Solution for Efficient Brake Caliper Maintenance
9 Review
Universal Car Ratcheting Caliper Piston Tool with 2 Steel Plates - Brake Caliper Press (Red, Two Size)
9 Review
π§ BMC Universal Vacuum Pump: Handheld Brake Bleeder Kit Ensuring Efficient Auto Service & Food Canning with Brake Bleeding Tester Set
9 Review
π Motive Products 0100 European Power Brake Bleeder Kit - Efficient Brake System Maintenance for European Vehicles
9 Review