Review on 🔴 Stark Glossy Red Smoke Tint Vinyl Wrap Film - Enhance Your Headlights, Tail Lights, and Fog Lights with 12"x 24" (1 x 2 Ft) by Kenny Hrdlicka

Just so you know I bought this for a very small project and didn't use it for headlights. I have interior lights that are brazed in and cannot be replaced so I wanted to tint their color a bit. For that it worked well. When using them on your headlights, it can be a little tricky to get a clean look if you are not familiar with installing these types of products. I don't know if this material is applied in a similar way to vinyl, but it seems like it could benefit from a liquid solution underneath to push out air bubbles. Again, I don't know if this product is like regular vinyl or if it loses adhesion if you go that route. If you try, then on a small piece. Anyway, I used a heat gun to get it to form curves. It heats up and expands slightly. This doesn't need too much heat so be careful as too much heat will cause it to quickly shrink where it wasn't placed. It has a protective coating on both sides of the film. When my roll arrived the outside was the sticky side. The other side also has a thin peeling layer. It can be tricky to get it out with your fingers, so I used an X-Acto knife to start. It fit me well, I just wish it was a little darker. It's near light blue ice.