🚘 Lamin-x T554Y Fog Light Covers: Enhanced Protection and Style for Your Vehicle Review

2019 Tacoma Off Road Short Bed Yellow Film, they work great! Easy to install (about 15 minutes). Turn on the fog lights to heat them up before applying the foil. This makes the material more supple.

One laminate is fully bonded with no problems but the other is not fully bonded around the edges. To be honest, for the money I would have expected there wouldn't be such issues. I hope the administration will solve this problem for me.

Pretty easy to apply, curved top sheets are not very easy and don't really work. If you have a 16-19 Tacoma, some YouTube videos say to pull the fog lights out of the inner fender. It was 10 times easier for me to pull and get him out from behind the G bars. Just one screw instead of 8.

They are very impressive and EASY to install even on a round lens by removing the light, cleaning with soap and water, then wiping with an alcohol wipe and starting in the CENTER of the lens and SLOWLY apply the vinyl in a circular motion towards the outside of the lens.

Used this for my 2019 Tacoma Sport. I had to remove the fog lights by unscrewing a Phillips screw as the stock fog lights are convex. The tint must match the fog lights exactly. Use a heat gun and machines to smooth out any wrinkles and/or air bubbles. Just take your time applying the shade and it should match.

This product is terrible. I've looked at a few YouTube videos and installation instructions and it just doesn't work for bulbous fog lights. I had to abandon my first attempt after too many tweaks because the creases wouldn't come out. My second try went a little better, but I'm going to rip it off because there are still creases that can't come out. They are not trimmed to later lie on protruding lights.

Installed on Tacoma 2019 factory fog lights. Thick laminate. Installation was easy. Because the lens is curved, it can be difficult to keep the edges down. After a month the laminate began to chip off. I worked laminate from the center of the fog lights. I used a heat gun and after I was done everything looked great. Over time it started to increase a little. Still not bad if you want to change the color of the fog lights.

I could do a better installation. Check out the installation instructions on the taco twonz YouTube channel. I actually need a heat gun and turning off the light is a lot easier than it looks, both of which I had to do. Otherwise you can do what I did and use my wife's hair dryer and stick it in the lens while the light is still in the truck. The result is not very good, but the quality of the film is excellent. Take your time, do it right, don't throw away the product because of poor…

The usual drive home finds me in the dark almost every day, and on rainy days my already poor visibility on the road deteriorates. Well, after doing some research, many people are lucky enough to use them to see it a little better with their fog lights in the rain and snow. I have to agree, they really help. My problem is that no matter what I do I can't get them to stay on the fog lights properly. They always show bubbles or wrinkles, even after cleaning the headlight with alcohol and…