Review on 🔌 Dorman 970-040 ABS Wheel Speed Sensor Wiring Harness - Premium Model Compatibility by Fred Novak

You will need to remove the tire and fender highlighted in blue here. The installation is quite easy. 1) Disconnect the old wiring harness from the wheel hub. 2) Remove the air filter, mass air flow sensor and pipe. 3) Disconnect connector at ABS module. 4) Insert a new wire harness into the wheel hub. into the engine compartment 6) cut the wire 3 inches from the ABS connector and connect it. I took needle nose pliers and squeezed the end of the breech to compress it to make it easier to launch. Once you've started, squeeze and squeeze again with needle nose pliers and squeeze a little more. Also try rocking until you are fully seated. No more ABS or traction control!