Review on 🖨️ Advanced Display for SCRIB3D Printing Pen by Sean Ceo

If you press the forward button to start the extrusion, the extrusion will continue until you press the button and press it again. In other words, you press a key to switch extrusions. This makes the stylus very difficult to use, precisely because the cheap buttons they used require little force to press. Enough force to make it impossible to hold the pen in your drawing. You can't hold down the button and stop the extrusion when you release it. It also automatically retracts when you stop extruding, which is also very annoying as not only does it not help at all against the tension, but there is also an unpredictable delay of a few seconds between the next time you start extruding and the actual start of the extrude Added plastic release. Also the pen software just doesn't make sense - there are 2 buttons to set the temperature, and in PLA mode you can set the temperature to no more than 180C. In ABS mode you can't set it less than 180C. It just doesn't make sense since 190˚C is best for PLA. And this is not my opinion, this number is indicated in the instructions that accompany the product. It is not possible to switch between ABS and PLA mode without disconnecting the pen. What I've mentioned so far is enough to convince me to just return it, but I also had a "reverse" function that doesn't work. I'm honestly flabbergasted, it seems like they should have tried to make this pen as bad as possible.