GARBAGE! Pretty sure the dies were set too tight for this part. As you can see the nipple meets the tee and it has been finger tightened! This has been the case with every nipple I have inserted into every fitting. Oooooh angry. 2 ball valves destroyed because I couldn't tighten the connection tight enough. My photos will give you all the evidence you need. Measurements versus properly manufactured brass male threads and a side-by-side comparison. Hear me now, trust me later.
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review