Review on 🔧 Anyyion Paintless Dent Repair Kit - 69pcs Car Body Dent Repair Tools - Auto Dent Puller Kit for Automotive Door Ding - Dent Slide Hammer, Glue Puller Repair Set (Starter Kit) by Brian Page

Fairly complete set. The glue gun is actually very convenient as it has an on/off switch and not just having to plug in or unplug it to turn it on and off. The glue they give you in the kit is rubbish and there are no real "finish" tabs in this kit. If you don't want to be frustrated when you start learning how to remove dents, buy yourself Burro Cactus Green Glue Sticks right after purchasing this set (and make sure it's a REAL Burro Cactus Green is ) from Keco Tabs along with a variety of flat-topped Blue Ice petals and a rubber-tipped tool. With these right adhesives, you can actually pull and open the tabs with excellent adhesion, which is very important. I learned it the hard way, so I'll tell you from my own experience. Yes, the glue they give you is garbage. However, the rest of the kit is good value considering what you get overall and then add the suggested items. With all that said, you're in a great place to get dents done RIGHT. By getting the right glue, those petals, and the attachment point along with this kit, I was able to do some pretty impressive work! Definitely watch some videos on unloading high pressure areas so it just reverses the dent flow and you can get rid of some pretty respectable dents! I was blown away at how well I was able to achieve excellent results with this kit and these few additional accessories. Most of the items in the set are very good quality for what they are and they are definitely worth the money even if the glue they give you is rubbish. It's worth the money with these extras that fix problems not listed in the kit. Top tip: You'll find that a slide hammer will get you out of most dents. The pop pen is cool, but you have to use different tools depending on what you're drawing. The tip is to DAMN make sure you don't have your hand over the edge of the striking side of this hammer when you hit it back. It's a pinch and a blood blister of epic proportions that will have you kicking patio furniture for a good hour, dropping F-bombs the whole time. Keep your hand on the bottom 2/3 of the slider handle and you'll be fine. A slide hammer works much more efficiently than an extrusion tool. The pull is much more direct and you get more power. An extrusion tool is best for working with a dent, where you can see the metal moving while pulsing the handle as the dent appears before it releases the adhesive. And don't press the tabs too hard into the glue. Make sure to wipe the dent and tongue tip with rubbing alcohol each time you tape the tongue. Carefully glue the tabs directly onto the dent area so that they are at a 90° angle as soon as possible after applying the glue to the tab. You want a thin layer of glue between the tongue and the surface, not pressing the tongue directly against the surface and touching it completely. Does it make sense? With Tack Weld Gray and Burro Cactus Green glues, you only have to wait about 30 seconds for a small hail dimple to appear. If you're pulling out a really big tongue with a lot of surface area to cure, wait two or three minutes. The idea is to pull when the glue is still tacky but firm and not "fully" cured. If you wait too long you won't get good strength on the deadlift. Pull too soon and you will have the same problem. There's a sweet spot and you'll feel it. In most cases, it takes several pulls and pops to repair a small dent. But it works wonderfully. As said, this kit and all the add-ons offered are the perfect place to start. Actually quite satisfied! And can actually save you a lot of DIY money! 👍🏻😎👍🏻