Review on π© Dernord Stainless Steel Hose Barb Fittings by Amrozi Goodall
1 " hose flash too small
Very well made but hose flash too small for 1" PE pipe. I have other 1" burr fittings for 1.075" OD tubing. They absorb polyethylene tubing with little heat and seal carefully. This fitting has a hose barb O.D. of .980 inch. No heat and pinch seals against domestic well pump pressure (55psi). The NPT thread was perfect.
- Industrial & Scientific
- Not sure
New products
Comments (0)
Top products in π§ Fittings
Vacuum cleaner Dreame V9 Global, white
145 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
