Review on Faztek Carbon Alignment Finish Thread Hardware by Joe Roberts

I use this with the Incra clamp in the angled slot of the Hammer K3 extendable table saw. Since the Felder/Hammer corner slot is more like a T-track, you'll need something on the leg of the clamp to make it work. They screw directly onto the Incra clamp. You'll have to disassemble the entire clamp, but it's not that difficult. Also note the miter/stock stop screw that comes with the saw. It requires a bit of maneuvering of the clamp + that t-nut to get in and out of the slot. Actually doesn't matter. But the best advice I can give is not to twist the clamp while it is in the moving ALUMINUM platform. You will damage the slot at an angle. And why press wood against an extendable table saw? This is for tearing long/thin material. Or simply clamp one end of the lumber so you can stand securely in the driver's seat while your lumber is pressed against one of the two angle bars provided. So you can get this + clip for about $20 or buy a concentric clip from Felder for $200. I bought 2 Incra clips and had them splurge! While I haven't done it yet, the number of T-Nuts that come with this kit is definitely inspirational to build jigs. Just take some flat head bolts that match those t-nuts and make whatever clamps fit in the fields/hammer slot.