
This works, but you'll need to make a few cuts at the attachment points to make it fit. To make sure it doesn't fall off I added some washers and an exhaust pipe gasket to keep the leek out. $12 is another cost to make it fit. The only thing I didn't like was that a small ruff was cut and stickers were put on the whistle. I had to use a wire brush to sand down the decal to keep it from burning/melting. I used to just remove the muffler and drive like that, but I think it helps reduce noise in the car and pump out some heat so the bumper doesn't melt. I had it for about 2 weeks with no problems.

50' Titanium Exhaust Heat Wrap Roll For Motorcycle Fiberglass Heat Shield Tape With Stainless Ties By LEDAUT 2
28 Review

Синтетическое моторное масло MOBIL 1 ESP 5W-30, 4 л, 1 шт
60 Review

Игровая приставка Valve Steam Deck 256 ГБ SSD, черная
59 Review

Vapor Canister Purge Valve Solenoid 1997278 For Chevrolet Trailblazer, Cavalier, Pontiac Bonneville, Oldsmobile - Replaces 214-641, 214-2246, 911-035 - EVAP Emission Purge Control Valve
30 Review

Комплект крепежа и скоб кузова автомобиля 820 штук – Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review

2007-2017 Jeep Wrangler JKU 4 Door Sunshade Mesh Top Cover - Durable UV Protection With US Flag Design - Voodonala
31 Review

Арки колесных ниш для джипа Wrangler 2007-2018 JK & JKU Unlimited - Мощные защитные арки из черного текстурированного стального материала (комплект из 4 шт.) от Hikotor для замены передних и задних арок (2 или 4-дверные варианты)
47 Review

Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review