820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda Review

Seriously don’t buy these at auto zone or o Reilly. These work great and you get wayyyy more bang for your buck The clips may not fit tightly enough and cause rattling noise.

I bought these because when I bought the replacement lights for my daughter 2002 civic they were listed as other people bought these when replacing lenses.They did not fit because they were two large.Fortunately I has a larger set and was able to complete the job

I used these for all the lower front bumper fasteners.Only found two places they are too big for which is in the front wheel wells.

I changed the headlight assemblies on my 2011 Honda Accord, and the process required me to remove several bumper fasteners. Due to wear and age all of them needed to be replaced. I was glad that I had these numerous replacement bumper fasteners.

Seems now days that every time we bring our Honda in to the dealer for service we find more things broken after getting it back. Took the van in for coolant change and found 4 fasteners missing and broken on the shroud. Looked up OEM parts online and found for less than the cost of two of them I could buy these. Perfect fit.If there is anything to not comment on positively it would be that I had to fish around in the bag while under the hood to find the pin part for the fasteners as this is a…

Figured I needed a few when working on my wife’s crv, so got 3 for $4 locally… then realized I needed about 20 to hold on the bumper! These are a firm fit and inspire confidence. One bag is enough for the bumper and trim around the area.

Had to remove the bumper of my TSX to replace the low beams. The old clippers kept breaking because they were old and dry. Bought these set and installed them all in less than 10 mins.

These are good plastic clips to replace those that inevitably break when you work on your car. I can't really tell much difference between these and factory clips. I just used one of these yesterday to fix a busted clip on a Subaru.Note that there are a myriad of styles and sizes - my advice is to stock a bunch of sizes so you'll have what you need when you need it. I bought a bunch and keep them in ziplock bags. Going out shopping for clips when your car is on the ramps is not a wise plan.

The price is fantastic. Stores charge a dollar or more per clip. The clips are shorter than many of the standard clips used to replace the bumper cover. The clips are nearly the same quality as Honda. The Honda clips have a small metal strip that extends from the sides of the clip that I assume are are used to hold the clips more securely when the plastic cover is secured to a piece of sheet metal I had to buy longer clips to complete my bumper cover replacement.If you need clips to replace or…

work great. been using not great fitting ones from auto parts stotes for years since honda is $4 a piece. found these and thought why didnt i look before lol. fit great and replaced missing ones in my fascia skidplate and upper grill. wish i had these when i worked in automotive.

Bottom line up front: fits better than the old factory ones. Good deal. Shipped fast.I took my 2015 Honda CR-V to a local shop to install some nice stainless bars/steps on the sides, and they cut the liner just right and everything was fine, but it started sagging. I thought that was that and I’d have to pull it all off. They had only tucked it in place and not refastened it everywhere. Two clips were in place on the frame, but not put through the liner. Those slackers had even used a zip tie…

Used these on my 2003 Honda Accord after changing my headlights. Perfect fit for the original fender clips. Many of the original clips were missing from from the bottom of the bumper. It is great to not have some sagging area of the bumper any more.On the 2003 there are two clips that I had to take out that these are not made for. Those two have a Phillips head plastic screw that break and do not screw out.

Wanted to write this review because I was looking for a replacement rivet fastener for my 2004 Dodge Durango for the rear tail lights. I searched high and log online and could not find them. Most people commenting in forums that they've been told they've been told they need to buy a whole new assembly by the deal in order to get those parts as they didn't sell them by themselves.That still may be the case as these are NOT identical BUT.they work great!Right before I bought these, I bought a…

These have a groove on each side this enables one to remove them and re use them. I used these to replace ones for my Honda that I had to destroy removing because some were not OEM fasteners. These do not have metal in them the oem ones have metal there are all plastic but work great and probably cost much less than original OEM.

These worked great in most places on my 2001 Honda Accord. However, they did not fit in the fender liner holes, which turn out to be less than 10mm. They are part 91512-SX0-003, which is 8mm.

The tool to remove fasteners work great, however the fasteners that come with tool don't work well. Fasteners are too big for opening. I will hold on fasteners to use for something else.

While they worked, they were not the only size needed. The suggestion by Best Buy was not complete. 8mm ones that are shorter and smaller diameter were also needed. Thanks for being incorrect, Best Buy. I had to go find four of the additional correct size to re-connect my fender liner. Good thing I had another vehicle to use.

Don't you just love those mechanics that just rip those snaps holding panels on and leave them loose? These snaps fixed major rattles under the hood that was driving me crazy, it was just the broken clips.RECOMMENDED

These are absolutely needed when replacing any trim or bumpers or grill for examples on any Honda car.Came in a little zip-loc pouch and arrived overnight as paid for.You can also buy 5 or 6 of these at advance auto parts that are specific to Honda but I needed lots so I purchased on here instead.Simple male piece fits and snaps into the Female B piece.This can be infuriating as the two pieces arrived already together, witch can not just be snapped into place.My suggestion is to take the two…

These clips look identical to the factory fasteners. I used them to replace some broken ones on my Acura RSX ft bumper. I recommend these to anyone who has a Honda or Acura.