Review on Corsair Crystal Series 680X RGB by Mateusz Biakowski ᠌

Caught on the advertit of this case on the Internet. Everyone praised him so much, and the body turned out to be junk. This is a regular case for 4k, maximum 7k. 80% of the cost is 3 fans with a stupid backlight controller that can’t even remember the backlight config, and it’s also stupid and the turntables just glow by default. If you have Linux, you can forget about backlight control, every time you start the backlight lights up first with standard colors. For 21k there is no fan controller, but backlit junk. The rear fan without pwm, given that there is no controller, it will make noise, as it works at maximum speed. For carriages for ZhD 2.5, I was ready to return this g . back, because this is the cheapest plastic that will fall apart on first use. I didn’t dare to disengage the carriages, since they would break, and I didn’t figure out how to do this at all. The compartments for the hard drive are too close and it is impossible to connect power to the hard drive normally without kinks and voltage on the connectors. There is a very high risk of damaging the HDD. Due to the location of the carriages in the second part of the body, it is impossible to make normal cable management there. Dust protection is a disgrace. They put a fly net like on Chinese cases for 1.5k. Bottom line: the body , not worth the money at all. After 2 months of operation, as promised, I am ating the review. 1. The fly net was completely useless. Miracles do not happen, a mesh with holes with a diameter of about 2-2.5 mm cannot protect against dust. This can be confirmed by any student who knows what dust is. + it is also inconvenient to clean. 2. The case is spacious, there is plenty of space in the working area, but even with such a space it is not convenient to install a video card and other components, since the fixing screws are in the case, and not on the reverse side.