Review on 🖨️ Enhanced Rich OPTO Photopolymer: Unmatched Printing Accuracy, Washable Formula by Rodney Gonzalez

This was my first purchase of a water washable resin and it won't be the last. It's very similar in performance to other resins I've bought, except I can flush with water instead of IPA. The color is very pleasant light gray, almost odorless. I mean. If you stick your nose in a bottle, it stinks a little. However, no odor could be detected during printing. In addition, this resin can make parts that are slightly less brittle than standard resin. One of the parts I've created and printed is a car door panel that needs to be bent slightly to snap into place. The standard resin I used didn't allow for sufficient flexing without breaking. This resin seems to take that bend well. The exposure time was about the same as the standard gray AC resin I used. I limit the cure time to 1-2 minutes or less depending on the size of the printed part and this resin seems to like the reduced cure time. So far I am very happy with this resin and it will be my new resin for simple models and parts.